REPSA Yellow Coat

Description

HUB and HUBG types watertigh hubs are used to terminate runs of threaded conduit through the wall of a electrical enclosure. They are available with or without ground screw. Ideal for use in pharmaceutical plants, chemical, petrochemical and food processing plants, pulp and paper factories and marine platforms. Resistant to a wide variety of chemicals.

Features

  • External PVC coating of 0.040¨ nominal.
  • 0.002¨ nominal yellow urethane interior coating.
  • Yellow urethane protection on the threads.
  • With PVC sleeve to ensure sealing.
  • Commercial sizes from 1/2¨ to 4” in diameter.
  • HUBG with steel grounding screw.
  • O-ring gasket to provide additional seal
  • Made of copper-free aluminum (4/10 of 1% max) and Zinc.

Exterior coating features

Hardness.

80-84 (Shore A Durometer).

Dielectric strength.

400 Volts/Mil at 60 cycles.

Aging.

1000 hours (Atlas wet UV chamber).

Elongation.

200% min.

Temperature.

Polyvinyl chloride has a crystallization temperature of 5° F (-15° C).

Flammability.

PVC coating will burn if exposed to continuous flame or heat above 400°F (204°C).

Toxicity.

Prolonged exposure to temperatures greater than 200°F (93°C) or fire may cause the PVC coating to release emissions potentially hazardous to the health of those exposed to them.

Conector para tablero de HUB de aluminio libre de cobre o zinc, adecuado para utilizarse en áreas CL-I, Div. 2, CL-II, Div. 1 y 2, CLIII, con opción a tornillo puesta a tierra, con recubrimiento exterior de PVC e interior con uretano amarillo, marca REPSA Yellow Coat®.
Certifications and compliances.

Download data sheet

HUB and HUBG type watertigh Hubs with exterior PVC coating and interior with yellow urethane

Ordering Information

WP Table Builder

Specify this product in your project:

HUB type watertigh Hubs (specify material: aluminum free of copper or zinc), suitable for use in CL-I, Div. 2, CL-II, Div. 1 and 2, CLIII areas, of (specify diameter, e.g.: 3/4”Ø), with exterior PVC coating and interior with yellow urethane, REPSA Yellow Coat®.

HUBG type watertigh Hubs (specify material: copper or zinc free aluminum), suitable for use in CL-I, Div. 2, CL-II, Div. 1 and 2, CLIII areas, of (specify diameter, e.g.: 3/4”Ø), with grounding screw, with exterior PVC coating and interior with yellow urethane, REPSA Yellow Coat®.